Champion-power-equipment 90720 Manual do Utilizador descarregar pdf (Página 12)

9 REV 90720-20131010

ENGLISH 90720

ASSEMBLY

A screwdriver can be inserted into the cylinder

rod’s bolt hole to rotate to proper position prior to

installing the ram bracket.

NOTE

The cylinder should extend in the opposite direction

of the beam as shown.

NOTE

6) Install the Ram Bracket to the Cylinder

1. Slide the ram bracket (#2) over the rod on the

cylinder being sure to align the bolt holes.

2. Insert the M10x60 bolt (#3) through the ram

bracket and cylinder rod.

3. Secure the bolt with M10 lock nut (#1). Do not over

tighten.

7) Install the Handle

1. Slide the handle (#31) into the tube bracket on the

end of the beam.

2. Secure with clip ring (#32).

8) Install the Hoses

1. Use 2 hose clamps (#9) to install the clear suction

hose (#19) from the pump inlet (A) to of the back of

the beam/tank (B) as shown.

2. Use 2 hose clamps (#9) to install the oil return hose

(#10) from the control valve outlet (D) to the back

of the beam/tank as shown (C).

3. Connect one end of the high-pressure hose

(#40) to the control valve outlet (E) and tighten

approximately ¼ turn past ﬁnger tight.

4. Rotate/adjust the high-pressure hose (#40) to run

to the inside of the fuel cap on the engine.

5. Thread the other end of the high-pressure

hose (#40) to the pump outlet (F) and tighten

approximately ¼ turn past ﬁnger tight.

5) Install the Cylinder to the Beam

1. Slide the cylinder pegs into the cylinder mounting

slots on the top of the beam.

2. Secure the cylinder retention plates (#20) with

M10x20 bolts (#23) M10 lock washers (#22) and

M10 washers (#21).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Sem comentários

Champion-power-equipment 90720 Manual do Utilizador Página 12